, ,

Token, Dice and Card Box STL to suit Necromunda Ash Wastes – 3D Printable Magnet Ready

AUD$4.45

This is a STL for a 3D printable token, card and dice box to suit Necromunda Ash Wastes and other games with the same dice, card and token size/number.

Prefer smaller, separate boxes? Check out this product instead.

It comes with a card and token scale finder so that you can test print a small section of it to see how the size goes on your particular printer, and adjust if necessary – without wasting a whole print to discover that. The default scaling works for most printers but I have had numerous comments that anything from 97% to 103% works for some people’s printer setup, so it’s worth checking before printing the whole thing.

Keen to hear any feedback – happy to adjust the design if required.

Suits 5x1mm magnets, takes four at most (two on the lid, two on the base). Helps keep the lid in place but still don’t tip it upside down unless you like a mess.

The base is nominally 16.9cm wide, 14.8cm deep and 7.83cm tall. The lid is 16.9cm wide, 14.8cm deep and 4.04cm tall.

THIS IS A DIGITAL PRODUCT AND YOU WILL NEED A 3D PRINTER OR ACCESS TO ONE TO MAKE USE OF IT. No physical product is provided.

Scroll to Top